All pedals can be installed and removed the same way. The right pedal has a right-hand thread (installs
clockwise, removes counterclockwise). The left pedal has a left-hand thread (installs counterclockwise,
removes clockwise).
Before starting the installation, we suggest you grease the pedal threads with white anti-seize paste. This will
prevent any oxidation which might hinder the removal in the future.
After correctly placing the pedals, you can hand tighten the crank taking care of the thread direction. Pay attention not to
force the movement because that may result in a damage to the pedal thread. After that we suggest you tighten the pedals
with a 15mm wrench key. The recommended torque is 29-34Nm, use a torque wrench to verify that.
The pedals are stamped “L” and “R” for left and right. Place the left pedal on the left crank and the right pedal on the right
crank.
The pedals setup is quite easy an operation requiring the supplied 15mm wrench key.
To Next Page
Loading...
