In order to recharge your e-bike battery, use only the supplied battery charger. We suggest you connect the charger to the
battery before plugging it into the power outlet (220V). Charging will start automatically. When fully charged, the charger
gauge will switch from RED to GREEN. You can now unplug the charger from the power outlet and from the battery right
after.
Battery and battery charger
Pantera is equipped with a latest-generation battery which is sheltered by a special waterproof protective cover. The
battery is available in two power variants, 500wh and 840wh
Always recharge the battery before storing your e-bike for a long time. This will avoid the self-discharge
phenomenon, an electro-chemical reaction provoking a loss of charge without any power consumption. Even if
lithium batteries are designed to limit this phenomenon, we recommend you fully charge the battery before
storing it to avoid any potential damage.
First of all, verify if the battery is correctly inserted into its specific emplacement. On delivery of the e-bike, the
battery is not set in position so we recommend you push it until when you hear a “click” noise.
At the end of its life cycle, the battery must be processed as a hazardous waste and properly disposed,
according to the local or regional legislation.
Pantera’s lithium battery features a BMS (Battery Management System) preserving it from overloading when
charging and avoiding the risk of a full depletion. BMS prevents short-circuits or other significant damages
which might jeopardize the duration of the battery.
The battery must be charged in a dry place, humidity should not exceed 15-30%.
Extreme temperatures may affect the life and duration of the battery.
To Next Page
Loading...
