To clean the chain, the derailleur and the cassette, you can uise rugs or a used or an old toothbrush. We
recommend you always use specific lubes and detergents.
Before riding on busy roads again, check all the gears and make sure that the chain and the derailleur are
perfectly working. In case the rear derailleur is not properly working, do not use bigger or smaller gears and see
immediately a professional bicycle service instead.
When properly and regularly attended, the duration of the chain is between 1.500 and 3.000 km
Turn off the battery power.
Use a rag to spread the lube all over the chain, between the chain links and in the inner part. Then switch the gears
while you manually operate the crankset. The chain will roll from one cog to another and spread the lube all over the
drivetrain system, including the derailleur.
When done with the lubrication, let the chain “rest” for a few minutes before spinning the crankset again in order to
uniformly spread the lube all over. After that remove excess lube and dirt from the chain.
Switch gears so as to use the lowest gear.
To properly lubricate the chain, follow the steps below:
To Next Page
Loading...
