Vespa LX 2012 User Manual

Engine oil top-up
The oil should be topped up after having checked
the level and in any case by adding oil without
ever exceeding the MAX. level.
Engine oil filter
The cartridge filter must be replaced every time the oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
Make sure the pre-filter and drainage plug O-rings are in good conditions. Lubricate them and refit the
mesh filter and the oil drainage plug, screwing them up to the specified torque. Refit the new cartridge
filter being careful to lubricate the O-ring before fitting it. Change the engine oil.
Recommended products
eni i-Ride PG 10W-40 Synthetic-based lubricant for four stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Oil pressure warning light
The vehicle is equipped with a telltale light on the
dashboard that lights up when the key is turned to
the «ON» position. However, this light should
switch off once the engine has started.
If the light turns on during braking, at idling
speed or while turning a corner, it is necessary
to check the oil level and the lubrication sys-
tem.
Maintenance Vespa LX - S 125 3V ie 150 3V ie (2012)
MAIN - 44

Vespa LX 2012 Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	124 cc
Cooling System	Air-cooled
Fuel System	Carburetor
Transmission	Automatic CVT
Fuel Tank Capacity	8.6 liters
Seat Height	785 mm
Curb Weight	114 kg
Length	1, 770 mm
Width	705 mm
Height	1, 140 mm
Max Power	10.3 hp @ 7, 750 rpm
Front Suspension	Single arm with coil spring and hydraulic shock absorber
Front Brake	200 mm
Rear Suspension	Coil spring and hydraulic shock absorber
Rear Brake	110 mm drum