Maintenance
57
Gearbox
Safety concerning maintenance work on the transmission
When working on the transmission the tractor must be stopped and
secured.
This prevents the machine from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected in
accordance with the instructions serious accidents causing damage to
limbs can occur.
When working on the transmission:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The PTO shaft must be disconnected.
• The tractor hydraulic system must be disconnected.
• The hand brake must be activated.
Pay attention when performing oil change
Use barrier cream or protective gloves when changing oil.
It will protect your hands against skin injuries.
Direct contact with the oil could lead to serious skin injuries.
Use the correct oil type
Always use the correct oil type for the transmission.
This will ensure the transmission has a long service life.
Using the incorrect oil type may damage the transmission.
Maintain correct oil level
The max. and min. oil level indicators on the transmission must not be
exceeded.
Correct transmission oil level will ensure a long service life.
Incorrect oil levels can cause the transmission to overheat, resulting
in serious damage.
Bevel gear
Checking the oil level
Every 80 hours of use
»Maintenance intervals« page 52
The oil level is checked as follows:
Remove oilplug 1.
Check that the oil is filled all the way up to the hole.
If necessary, remove oilplug 2.
Fill the oil to the correct level.
Fit oilplug 1 and 2 to the transmission.
»Lubricants« page 94
To Next Page
Loading...
