14
In the "Main menu", you can call up and adjust all of
the remaining settings for the control unit's range of
functions.
Call up the "Main menu" as follows:
■
Standby display active:
Tap anywhere on the screen and then tap .
■
From the home screen:
Tap .
■
From anywhere in the menu:
Tap and then .
Menus available in the "Main menu":
Vitotronic 300 Vitotronic 100 Further details:
See page
"Block/enable boiler" "Block/enable boiler" 31
"Boiler sequence" — 34
"Test mode"
For the flue gas inspector only
"Test mode"
For the flue gas inspector only
40
"Settings"
E.g. – display brightness
"Settings"
E.g. – display brightness
31
"Heating"
For central heating settings, e.g. – the
"Time program".
—
22
"DHW"
For DHW heating settings, e.g. for the
"DHW temperature".
—
28
"Information"
To check operating data, e.g. temperatures
"Information"
To check operating data, e.g. temperatures
36
Energy saving function "Holiday pro-
gram"
— 26
"Service"
For contractors only
"Service"
For contractors only
—
Using / you can scroll through the menu. Note
The menus available depend on your heating system
equipment.
Menu overview with all menus: See page 52.
Information in the "Energy cockpit"
The "Energy cockpit" provides you with clear infor-
mation on the energy state of the components in your
heating system.
Note
The "Energy cockpit" is only shown if it was set up
during commissioning. If necessary, notify your con-
tractor.
Tap the following on-screen buttons:
1. If required, for the home screen
2. / for "Energy cockpit"
Note
When you call up the "Energy cockpit" for the first
time, you will be notified that the values shown cannot
be used for settling bills with the power supply utility.
■
The "Energy cockpit" is opened once you confirm
this notification with OK. This notification will not
appear again.
■
If you tap Cancel, the "Energy cockpit" will not be
opened. The notification will be shown again next
time.
Control unit operation
Overview of the "Main menu"
5863758
To Next Page
Loading...
Need help?
General
