21
Make the settings for central heating at
the Vitotronic 300-K.
If you want central heating, check the
following points:
■ Have you selected the heating circuit?
For settings, see the next chapter.
■ Have you set the required room tem-
perature?
For settings, see page 22.
■ Have you set the correct heating pro-
gram?
For settings, see page 22.
■ Have you set the required time pro-
gram?
For settings, see page 23.
Selecting a heating circuit
The heating of all rooms can, if neces-
sary, be split over several heating cir-
cuits.
■ In the case of heating systems with
several heating circuits, for all central
heating settings, first select the heat-
ing circuit where you want to make a
change.
■ This selection is not possible in heat-
ing systems with only one heating cir-
cuit.
Example:
■ "Heating circuit 1" is the heating cir-
cuit for the offices on the ground floor.
■ "Heating circuit 2" is the heating cir-
cuit for the offices on the first floor.
The heating circuits are marked at the
factory as "Heating circuit 1" (HC1),
"Heating circuit 2" (HC2) and "Heating
circuit 3" (HC3).
If you or your heating contractor have
renamed the heating circuits (e.g. as
"Ground floor" etc.), the name is dis-
played instead of "Heating circuit ..."
(see page 34).
Extended menu
1.
2. "Heating"
To Next Page
Loading...
