Viessmann GC1 - Heating System with DHW Circulation Pump

31
Deleting a time phase
Set the time for the end point to the same
time that was set for the start point. The
display shows the selected time phase
"- - : - -".
DHW
Adopt with
HC1
§
u
0 2 4 6 8 10 12 14 16 18 20 22 24
?
- -:- - - - -:- -
u
---
ON
Mo-Fr
- -:- - - - -:- -
OK
DHW heating once, no longer in the
time program
Note
The heating program "Heating and
DHW" or "Only DHW" must be set for at
least one system heating circuit.
Extended menu
1.
2. "Heating"
3. "Party mode"
4. Disable "Party mode" again with
"OFF" to prevent unintentional cen-
tral heating with standard room tem-
perature.
Heating system with DHW circulation pump
For further information about the DHW
circulation pump, see chapter "Terminol-
ogy".
■ Automatic mode is set for the DHW
circulation pump time program. In
other words, the DHW circulation
pump operates in parallel to the DHW
heating time program.
■ If you don't want the automatic mode,
you can select up to 4 individual time
phases per day for the DHW circula-
tion pump, which can be the same for
every day of the week or different. Set
the start and end points for each time
phase.
■ In the "Information" menu, you can
scan the current time program (see
chapter "Scanning information",
"DHW" group).
Note
Activating the DHW circulation pump is
only advisable for those times when
DHW is actually drawn.
Extended menu:
1.
2. "DHW"
3. "DHW circ time prog"
4. "Individual"
5. Select part of the week or a day.
6.
Select the time phase !, ?, § or
$
.
7. Set the start and end points for the
relevant time phase.
8. Press to exit the menu.
Note
If you want to terminate a time phase
setting process prematurely, keep
pressing until the required display
appears.
DHW heating
Setting the time program for DHW heating
(cont.)
5592 675 GB