Viessmann GC1 - Entering Names for the Heating Circuits

34
Only for the Vitotronic 300-K.
You can give heating circuits 1, 2 and 3
("HC1", "HC2" and "HC3") individual
names. The abbreviations "HC1",
"HC2" and "HC3" will be retained.
Extended menu
1.
2. "Settings"
3. "Name for heating circ."
4. "Heating circuit 1", "Heating circuit
2" or "Heating circuit 3"
5. "Change?"
6. You can select the required symbol
with / .
7. / takes you to the next character.
8. Press OK to accept all entered char-
acters at once and simultaneously exit
this menu.
Note
The entered term is deleted with
"Reset?"; "Heating circuit 1" will
then be shown again.
Example:
Name for "Heating circuit 1":
Ground floor
Heating circuit 1 HC1
Change with (
Heating circuit 1
s
t
q
p
r
Heating circuit 1
Adopted
Ground floor
HC1
The menu shows "Ground floor" for
"Heating circuit 1".
Ground floor
Set reduced room temp
Select with (
Set room temperature
Economy mode
Party mode
Ù
Ú
HC1
Ground floor
ß
22 °C
Further adjustments
Entering names for the heating circuits
5592 675 GB