ViewSonic SC-T46 - Page 188

Conguring Client Settings
Conguring Service Access Settings
177
177
Common Settings
Item Description
Non-Interactive Mode
Select Yes or No to allow or disallow the Non-Interactive mode. The default is to
use the Non-Interactive mode.
Option Description
Yes
The Non-Interactive mode is used. Users are not allowed to
re-select different settings if the settings have been specied
in View connection settings.
No
The Interactive mode is used. Users are allowed to
re-select different settings even if the settings have been
specied in View connection settings.
Autostart When Startup
Select whether to open a VMware View or Horizon View session automatically or
not when your SC-T46 is started up (Autostart mode).
NOTE: There are three similar but different modes for your SC-T46 and only one
mode will take effect if all are enabled. Three modes and the order of
priority are listed as follows:
No. Mode Description
1 Appliance
The client will start up directly with the desired
VMware View or Horizon View session and turn off
after existing the session.
2 Autostart
The client will start up directly with the desired
VMware View or Horizon View session and perform
the congured action after existing the session.
Available actions include:
• Returning to the local desktop
• Re-launching a new session
• Restarting the thin client
• Turning off the thin client
3 Quick Connection
The default. The client will enter ViewSonic Quick
Connection screen after system startup.
NOTE: To use the Autostart mode, ensure that the Appliance mode is disabled.
On Application Exit
Select what to do when a VMware View or Horizon View session is ended.
Four options are available: Do Nothing, Restart Application, Reboot,
and Shutdown.
Option Description
Do Nothing Returns to the local desktop.
Restart Application Opens a VMware View or Horizon View session again.
Reboot Restarts your thin client.
Shutdown Turns off your thin client.