63
41018
Advanced configuration from PC
Updating
Manual updating
Automatic updating
In the event of installation in systems with Due Fili Plus technology (with audio video module 41002, 41005), use the PC
configuration software "SaveProg", connecting to the audio/video module via USB.
In the case of installation in systems with IP technology (with audio video module 41006.1), use the PC configuration
software "Video-Door IP manager", connecting to the system network.
The configuration software is available from the website www.vimar.com.
When installed in an Elvox IP video door entry system, i.e. connected to the electronic audio-video module art. 41006.1,
the device is automatically updated by the electronic module to which it is connected.
Operation of the updating procedure is signalled by the LEDs on the 41006.1, as described in relative installation manual.
Cautionupdate the display with a suitably powered PC, or with a fully-charged battery.
If, in the case of a battery-powered PC, the updating process is stopped, this will be due to an low battery level, which is
not sufficient to power the USB output used for the update. It will therefore be necessary to repeat the procedure while
the PC is powered directly from the mains electricity supply.
Note: the device is able to operate with module 41006.1 only if equipped with firmware version 1.19 or later.
If this is not the case, when connected to the 41006.1, the message “Upgrade the modules” will be displayed during the
start-up phase (see Notification messages): perform the manual updating procedure using SaveProg/FWUpdate, as
describe previously; on completion of the procedure, re-connect to the 41006.1.
1. Disconnect the Display from the other modules and any auxiliary power supply
2. Connect the Display to a PC (where the SaveProg/FWUpdate or WinBoot software is installed) via USB cable
3. Launch the update within 30 seconds; after 30s the device automatically exits the update phase.
4. During the update the OK button LED will remain lit and the display will not show any images.
To Next Page
Loading...
