VM1000C Pilot’s Guide Page
13
certain alarms or manually activated by holding until the MAN
and RPM field decimal points begin blinking.
DOWNLOAD:
USB Download:
• Insert your USB Flash Drive into the VM1000C USB connector
• The VM1000C will change the display to
o All gauges will blank out
o MAN digital area will display 74.0
o RPM digital area will display NEW
• Press and hold button 2 to switch to ALL flights mode.
• Press and hold button 3 to start download.
o Observe RPM count up as flight data recorder system is
written to the Flash Drive.
o When flight data recorder information has been written
to the drive, the VM1000C will restart.
• After data download completes, the VM1000C will restart. Do
not remove the USB flash media until the VM1000C restart
is complete (gauges are displayed).
Serial Download:
• Insert JPI serial download cable (PN 900PCCABLE) into the
serial download connector
• Start EzTrends
• Click Download and Archive Data from your EDM
To Next Page
Loading...
Need help?
General
