Page 38 Vision Microsystems Incorporated
Route the Fuel Flow Transducer Wires
Route the thermocouple and fuel flow wires from the probes through the
firewall using fireproof rubber grommets and flame retarding silicone.
Use an existing hole if possible. Following the existing wiring harness
and connect to the indicator marking each lead with the cylinder number.
All wires must be routed away from high temperature areas (exhaust
stacks, turbochargers, etc.). Secure Probe leads to a convenient location
on the engine approximately 8 to 12 inches from the probe, being sure
there is sufficient slack to absorb engine torque. It is essential in routing
the probe and fuel flow transducer wires not be allowed to touch metal
parts of the air-frame or engine since abrasion will destroy this wire.
After running the engine, check the fuel hoses, transducers and
fittings for leaks.
Section 4 - INITIAL SYSTEM SETUP
System Setup
There are two ways to configure the parameters of the VM1000C: use
the provided VisionConfig program running on a PC or directly using
the built in setup menus.
VisionConfig Setup
Overview
The VisionConfig assists you in configuring the VM1000C. The
VM1000C has numerous parameters that control the operation of the
unit. All the user parameters can be modified by using
VISIONCONFIG. VISIONCONFIG provides a MSWindows™
based utility that facilitates modifying these parameters in a user
friendly way.
Installation
On your PC, execute
VISIONCONFIG setup.exe. Follow the
instructions to install the program. The default installation directory
is “C:\Program Files\J.P. Instruments\VISIONCONFIG”.
To Next Page
Loading...
Need help?
General
