VM1000C Pilot’s Guide Page
47
Command Line Format
When the programs detects the parameters defined on the command
line, it will read the command line, transfer configuration data and
save them in the specified file automatically. There are total four
parameters on the command line:
1. /FILE: the full path of the configuration file.
2. /AUTO: the transfer mode.
3. /PORT: COM port name.
4. /BAUD: the baud rate.
The format of the parameters is as the following:
/file=c:\VISIONCONFIG\test.cfg
/auto=download (or upload)
/port=com1
/rate=19200
They are non case sensitive.
Built-in VM1000C Setup
Setup the VM1000C by performing various steps in the Setup Menu
or use Vision Config. All steps within the Mandatory Setup section
must be accomplished first. Next, verify your actual engine limits
agree with the instrument limits by stepping through all of the
ENGINE MENU limits. Adjust any displayed graphics/values/limits
to match the requirements for your engine/airframe. Finally perform
any optional setup, such as fuel level calibration, dimming
adjustment, amps zero, manifold calibration, datalog interval, RS232
setup for GPS, data log, VMFPS data ports, EC100 checklist
download.
IMPORTANT: Test your datalog port connections using a
communications program such as Teraterm or Hyperterm.
During setup, the MAN field displays the current menu item. Accept
it (by pressing
). In many cases, the RPM field shows an associated
value, except ENGINE MENU where gauge range marks and the
associated limit values are shown.
To Next Page
Loading...