vision microsystems VM1000C - Fuel Level System Calibration; Basic Fuel Tank Calibration Steps

VM1000C Pilot’s Guide Page 53
5
5 5
5 I. I
I. II. I
I. I
EGT
• bottom segment
• top segment
• Autotrack tolerance
• Alarm tolerance
5 I.2
5 I.25 I.2
5 I.2
TIT
• low green
• high green
• high red (tithi)
• low red (titln)
• Autotrack tolerance
• Alarm tolerance
60.0
60.060.0
60.0
Fuel Level
Calibration
60. I
60. I60. I
60. I
• range marks desired
Perform the following steps for each tank you are using:
1. Add desired unit of fuel (we recommend 2 gallon
increments) (do a 0 cal first)
2. Hold 

 or 

 to set the current total of fuel in tank.
(displayed on fuel indicator)
3. Calibration number will change as fuel level change (RPM
display)
4. Tap 

 to accept this data point. (value will increment to
next minimum allowed)
5. Repeat 1 thru 4 until the tank is full and final data point
accepted then tap 

 next
If a Calibration has already been done, it must be erased before
performing the calibration again. See page 49
60.2
60.260.2
60.2
PRIMARY left fuel
tank cal
60.3
60.360.3
60.3
PRIMARY Right fuel
tank cal