Visionary Solutions Duet E-2 - Page 33

Visionary, Network Audio Video
30
DUETE-2/DuetD-2 USER MANUAL
ENCODER OPTIONS
IP.ADDRESS – Shows the current value based on the unit’s mode. In Static mode, shows the unit’s static settings. In DHCP mode,
shows if the values are valid. If DHCP is failed, the mode shows as Auto IP (even though you cannot select this mode directly), and
the Auto IP values display in the IP.xxxxxx fields. See section Configuring Encoder and Decoder IP Addresses.
IP.NETMASK – Shows the current value based on the unit’s mode. In Static mode, shows the unit’s static settings. In DHCP mode,
shows if the values are valid. If DHCP is failed, the mode shows as Auto IP (even though you cannot select this mode directly), and
the Auto IP values display in the IP.xxxxxx fields. See section
Configuring Encoder and Decoder IP Addresses.
IP.GATEWAY – Shows the current value based on the unit’s mode. In Static mode, shows the unit’s static settings. In DHCP mode,
shows if the values are valid. If DHCP is failed, the mode shows as Auto IP (even though you cannot select this mode directly), and
the Auto IP values display in the IP.xxxxxx fields. See section Configuring Encoder and Decoder IP Addresses.
IP.DNS_SERVER – (optional) Shows the current value based on the unit’s mode. In Static mode, shows the unit’s static settings. In
DHCP mode, shows if the values are valid. If DHCP is failed, the mode shows as Auto IP (even though you cannot select this mode
directly), and the Auto IP values display in the IP.xxxxxx fields. See section
Configuring Encoder and Decoder IP Addresses.
IP.VLAN_TRUNK_MODE – Modes are TRUE and FALSE. See section Configuring Encoder and Decoder IP Addresses.
IP.VLAN_TAG_STREAM – Used to assign stream (LAN1) VLAN tag when IP.VLAN_TRUNK_MODE is set to TRUE. See section
Configuring Encoder and Decoder IP Addresses.
IP.VLAN_TAG_DANTE - Used to assign Dante (LAN1) VLAN tag when IP.VLAN_TRUNK_MODE is set to TRUE. See section
Configuring Encoder and Decoder IP Addresses.
IP.VLAN_TAG_EXPANSION - Used to assign expansion port (LAN2) VLAN tag when IP.VLAN_TRUNK_MODE is set to TRUE. See
section Configuring Encoder and Decoder IP Addresses.
UNIT.PSE_ENABLED – Used to enable PoE power transmit out LAN2 expansion port. When the DuetE-2 is supplied PoE+ power
from the network switch and UNIT.PSE_ENABLED is set to TRUE, the encoder will transmit PoE power out the LAN2 expansion
port.
Note: DuetE-2 must be supplied with PoE+ power from the network switch to transmit PoE power out the LAN2 expansion port.