Visionary Solutions Duet E-2 - DuetE-2 Encoder Configuration Tab

Visionary, Network Audio Video
31
DUETE-2/DuetD-2 USER MANUAL
ENCODER OPTIONS
DUETE-2 ENCODER CONFIGURATION TAB
STREAM.RTP_ADDRESS – Used to set RTP audio stream address. See section Audio Settings.
STREAM.RTP_PORT – Used to set RTP audio stream port. See section Audio Settings.
STREAM.MODE – Unicast or multicast. See section Configuring Stream Settings (Manually).
STREAM.BIT_RATE – See section Stream Bit Rate.
STREAM.FRAME_RATE – See section Stream Fame Rate.
STREAM.QOS_DSCP - Used to set the QoS DSCP tag (default is set to 26)
STREAM.AUDIO – Select the source of audio for the AV over IP stream - HDMI, Analog, Dante - See section Audio Settings.
STREAM.VIDEO – Used to set encoder input source select – AUTO, HDMI1, HDMI2, USB-C
STREAM.VIDEO_PRIORITY - Used to set encoder input select priority when STREAM.VIDEO is set to AUTO.
AUDIO.VOUME – Hidden until STREAM.AUDIO is set to ANALOG. Used to set the signal level for the analog audio input (default set to
80).