Visionary Solutions Duet E-2 - Audio Settings

Visionary, Network Audio Video
21
DUETE-2/DuetD-2 USER MANUAL
CONFIGURATION
VIDEO FORMAT SETTING (DECODER ONLY)
By default, the VIDEO.FORMAT field on the DuetD-2 decoder is set to Source. This means that the same source resolution being
encoded by the currently “tuned” DuetD-2 is passed through to the output. This is for cases where you are certain that the display
connected to the DuetD-2 can handle any of the source resolutions that it may be tuned to. If the connected display cannot show an
encoded resolution, set this field to a value that the display can decode. For example, if you are tuning a 4K encoded stream and are
using an HD display
, set this value to 1080P60. The decoder will scale the tuned stream to 1080P60 and allow the display to show the
stream.
AUDIO SETTINGS
AUDIO S OURCE
The Duet-2 series is capable of using HDMI, Analog, or Dante audio sources.
• The DuetE-2 encoder uses the STREAM.AUDIO to select the source of audio sent over the AV over IP stream.
• The DuetD-2 decoder uses the STREAM.AUDIO to select what audio is sent out the HDMI output.
STREAM.AUDIO=HDMI
DuetE-2 – STREAM.AUDIO = HDMI
1. Encoder receives HDMI or USB-C input with embedded audio. The audio must be available as LPCM for it to properly be sent as
Dante™.
2. Encoder converts LPCM to up to 2 Dante audio channels and makes them available as a transmit device on the Dante network.
3. Encoder takes embedded HDMI or USB-C audio (same as above) and encodes it into the AV over IP stream that includes video.
DuetD-2 – STREAM.AUDIO = HDMI
1. Decoder receives AV over IP stream with both audio and video and decodes it to the HDMI and USB-C output.
2. Decoder makes the decoded audio (up to 4 channels) available as a transmit device on the Dante™ network.
STREAM.AUDIO=DANTE
DuetE-2 - STREAM.AUDIO=DANTE
1. Encoder receives HDMI or USB-C input with embedded audio. The audio must be available as LPCM for it to properly be sent as
Dante™.
2. Encoder converts LPCM to up to 2 Dante audio channels and makes it available as a transmit device on the Dante™ network.
3. Encoder takes up to 4 channels of Dante™ audio selected via Dante™ Controller or other software and encodes it into the AV over
IP stream that includes video. This allows the insertion of Dante™ network audio into the AV stream so that decoders can access
the audio even if they are not Dante™ capable.
DuetD-2 - STREAM.AUDIO=DANTE
1. Decoder receives AV over IP stream with both audio and video and decodes just the video to the HDMI and USB-C output.
2. Decoder makes the decoded audio (up to 4 channels) available as a transmit device on the Dante™ network.
3. Decoder takes up to 4 channels of Dante™ audio selected via Dante™ Controller or other software and embeds it into the HDMI
and USB-C
output as LPCM
audio.