23
After the voice messages were programmed in to the VS4500 memory, they can be used to send voice messages to devices
that support voice messages such as wireless speakers, voice pagers or telephone subscribers (requires VS3003 Telephone
Interface). The message ID and settings are determined by the parameters stored in the DSC field. For example:
1. If device 201 is of the Wireless Speaker type, when it is accessed from the wireless messages or the keypad, the VS4500
will send the voice message stored in the DSC field to the speaker/s represented by device 201.
2. If device 401 is of the Phone type, when it is accessed from the wireless messages or the keypad, the VS4500 will dial
out to the telephone number stored under that device and send the voice message stored in the DSC field to the telephone
subscriber.
To program the DSC field, use the ttrd format where:
t is the Alert Type (two digits number from 01 to the number of alerts supported by the receiver).
r is the Repeat (digit between 1 and 9)
d is the Delay (digit between 1 and 9) in seconds between repeats
Note: For automated voice messaging to telephone subscribers, it is recommended that the r parameter will be set to
5 or higher.
To Next Page
Loading...