visiplex VS4500 - 3.1.10 Wireless Setup Menu

13
3.1.9 Sunset / Sunrise Menu
Use this option to display the current settings for sunset and sunrise.
From the Administration Menu, select 9 followed by the # key. The following screen will be displayed:
SUNSET/SUNRISE:
R06:22 S17:43
Following is the description of the displayed information:
R: Sunrise time as indicated by the following 5 characters
S: Sunset time as indicated by the following 5 characters
Press the * key to return to the Administration Menu.
3.1.10 Wireless Setup Menu
From the Administration Menu, select A followed by the # key. The following screen will be displayed:
WIRELESS SETUP:
PA VOLUME
This screen allows the administrator to configure different wireless settings of the VS4500.
Press the key representing the field followed by # key to edit the settings. Following are the fields description:
1 - PA Volume
Determines the default volume used in voice messaging. Enter a value of 1 (lowest), 2
, 3 or 4
(highest) followed by # key to save the settings.
2 - PA Timeout
Determines the time period after which the transmission of voice message will be terminated.
Enter a value between 1 and 8 or 0 followed by # key to save the settings:
1 – 30 seconds
2 – 60 seconds
3 – 1.5 minutes
4 – 2 minutes
5 – 2.5 minutes
6 – 3 minutes
7 – 3.5 minutes
8
– 4 minutes
0 - 15 Minutes
3 - Time Sync Mode
Determines if time synchronization signal should be sent to wireless clocks. Enter a value
between 0 and 2 followed by # key to save the settings:
0 – Disabled
1 – Enabled
2 – Controlled by a PC software
4 – DL Saving Mode
Determines if time synchronization Daylight Saving time is on or off. Enter a value between 0
and 1 followed by # key to save the settings:
0 – Disabled
1
– Enabled
5 – Time Sync Slot
Determines when the time synchronization signal should be sent. Enter a value between 0
and
6 followed by # key to save the settings:
0
– 15 seconds after top of the minute for TS4xxx and TS5xxx clocks.
1 – 30 seconds after top of the minute for TS4xxx and TS5xxx clocks.
2 – 45 seconds after top of the minute for TS4xxx and TS5xxx clocks.
3 – Top of the minute for TS4xxx and TS5xxx clocks.
4 – Top of the minute for TS-CLK-xxxx clocks, 15 seconds after top of the minute for TS4xxx
and TS5xxx clocks.
5 – Top of the minute for TS-CLK-xxxx clocks, 30 seconds after top of the minute for TS4xxx
and TS5xxx clocks.
6 – Top of the minute for TS-CLK-xxxx clocks, 45 seconds after top of the minute for TS4xxx
and TS5xxx clocks.
6 – Daytime Sync
Determines if time synchronization signal should be sent during daytime or only during
nighttime. Enter a value between 0
and 1 followed by # key to save the settings:
0
– Activate time synchronization signal during nighttime only (1:50AM to 2:10AM, 12AM to
3:30 AM on Day Light Saving change date).
1 – Activate time synchronization every minute during daytime.
7 – MC Sync Time
Determines the time when a wireless signal should be sent to a Master Clock Synchronizer to
close contact.
Enter a valid time in 24 hours format (for example, for 6PM,enter 1800).