visiplex VS4500 - 1.7 Pre-Installation Test for Wireless Clocks

7
1.7 Pre-Installation Test for Wireless Clocks
It is recommended to test the VS4500 and the entire system prior to installation in order to verify proper operation and get
familiar with the unit operation.
Follow these steps to perform a pre-installation test:
1. If your system is equipped with an internal transmitter, connect the BNC antenna cable to the RF-OUT terminal at the
back of the VS4500.
If your system uses an external transmitter, connect the transmitter data cable between the VS101-XX transmitter and
the DATA I/O port at the back of the VS4500. Connect the antenna to the external transmitter’s RF-OUT terminal.
2. Connect the provided power supply to the POWER jack at the back of the VS4500 and turn the power switch to ON
position. The main menu should appear with the PAGE TO: displayed on the top line.
If you are using an external transmitter, make sure it is powered on.
3. Press the B key for the Administration Menu and enter the default password (4500). The menu top line should display
SELECT OPTION:
4. Press 2 followed by the # key for the internal clock Time Setup. Enter the UTC (Universal Coordinate Time) or GMT
(Greenwich Mean Time) time in 24 hours (military) format. The display will change back to Time Setup.
5. Press 3 followed by the # key for the internal clock Date Setup. Enter the UTC (Universal Coordinate Time) or GMT
(Greenwich Mean Time) date in MMDDYY format. The display will change back to Date Setup.
6. Press 6 followed by the # key for the Time Zone Setup menu. Enter the offset in hours of the local time zone from UTC
(Universal Coordinate Time) or GMT (Greenwich Mean Time) time. Use 01 to 23 for negative offset (GMT -1 to GMT -23),
00 or 24 for GMT time, 25 to 47 for positive offset (GMT+1 to GMT+23).
The display will change back to Time Zone Setup.
7. Press A followed by the # key for the Wireless Setup menu. Press 3 for the Time Sync Mode menu followed by the #
key. Press 1 followed by the # key to enable time synchronization.
8.
Press the * key to return to the Main Menu.
9. Press C to start the transmission of time synchronization every minute (installation mode).
Within a few minutes, the VS4500 will start sending the time information page every minute. Set a clock to receive
signal and make sure it receives and displays the correct time as displayed on the VS4500 display.