19
RD-101 | Version 1
Input settings
The settings for each individual
input can be adjusted in the
menu.The input selection is
saved automatically every
10 minutes. Each time you
initialize the RD-101, the last
saved setting is restored.
Input name settings
By default, the inputs are
named DIG 2/3/4/5, USB and
Streamer. In the text-menu you
can find a list of predefined
input names. If the name of
your device is not in the list,
you can choose to make your
own device name.
Streamer
Here you can set the RD-101
to automatically check for
firmware updates for the
streamer. In the streamer
settings the update check can
be enabled/disabled.
(note: all firmware updates
made availible are testet and
approved by Vitus Audio).
Input gain settings
Offset gain setting / Sensitivity
setting. Different sources often
have different output voltages.
This has a direct influence on
the typical volume level that
is needed for a specific sound
level, hence changing between
sources can result in high
sound level differences. To
accommodate easy operation,
we have included a gain (or
as some prefer to call it –
sensitivity setting) in our DACs
– it simply sets the volume
starting point at a specific
volume – to match the source.
The offset-value can be set
from - 12 dB to +12 dB in steps
of 0.5 dB.
Disabling inputs
If you only use some of the
inputs, it is possible to disable
the inputs that are
not used. Using the “Input”
button, the system skips the
disabled inputs, and jumps to
the next input.
3. operation
3. operation
To Next Page
Loading...