18
RD-101 | Version 1
You can modify the settings
of the RD-101. You do this by
entering the menu. You can
find a graphical reproduction
of the menu. The sub-menus
are indicated with a colour.
OUTPUT RESET REMOTE,
V.INI/BP VOL, BRIGHT and
INPUTS.
In the Appendix ( chapter 7
of the manual ) you can find
various examples of how to
change the settings of the RD-
101.
Remote settings
The RD-101 is shipped with a
Apple Remote.
The Apple remote that
comes with the RD-101 can
be used on all Reference
devices. If you own two (or
more) reference devices then
it is recommended that you
pair the remote(s) with their
devices.
Volume settings
The RD-101 starts up in
the same volume step on
initialization. You can select
in which volume step, the RD-
101 should initialize. You can
set the initial volume step in
the menu, to a step between
-121.5 dB and 0 dB.
You can also set the initial
volume-step to “REMEMBER”.
When you set the RD-101
to “REMEMBER”, then it
remembers the volume step
from when it was put to
standby. Next time the RD-101
leaves standby, it will start in
this volume step.
3. operation
RD-101 Menu: introduction
To Next Page
Loading...