CONFIDENTIAL
–
DO NOT COPY Page 7-33
File No. SG-0204
Operations:
Reads
Subsequent to programming the mode register with CAS latency, burst type, and burst length, Read
bursts are initiated with a Read command.
The starting column and bank addresses are provided with the Read command and Auto Precharge
is either enabled or disabled for that burst access. If Auto Precharge is enabled, the row that is
accessed starts precharge at the completion of the burst, provided tRAS has been satisfied. For the
generic Read commands used in the following illustrations, Auto Precharge is disabled.
During Read bursts, the valid data-out element from the starting column address is available
following the CAS latency after the Read command. Each subsequent data-out element is valid
nominally at the next positive or negative clock edge (i.e. at the next crossing of CK and CK). The
following timing figure entitled “Read Burst: CAS Latencies (Burst Length=4)” illustrates the general
timing for each supported CAS latency setting. DQS is driven by the DDR SDRAM along with output
data. The initial low state on DQS is known as the read preamble; the low state coincident with the
last data-out element is known as the read postamble . Upon completion of a burst, assuming no
other commands have been initiated, the DQs and DQS goes High-Z. Data from any Read burst
may be concatenated with or truncated with data from a subsequent Read command. In either case,
a continuous flow of data can be maintained. The first data element from the new burst follows either
the last element of a completed burst or the last desired data element of a longer burst which is
being truncated. The new Read command should be issued x cycles after the first Read command,
where x equals the number of desired data element pairs (pairs are required by the 2n prefetch
architecture). This is shown in timing figure entitled “Consecutive Read Bursts: CAS Latencies (Burst
Length =4 or 8)”.A Read command can be initiated on any positive clock cycle following a previous
Read command. Nonconsecutive Read data is shown in timing figure entitled “Non-Consecutive
Read Bursts: CAS Latencies (Burst Length = 4)”. Full-speed Random Read Accesses: CAS
Latencies (Burst Length = 2, 4 or 8) within a page (or pages) can be performed as shown on
following:
To Next Page
Loading...
Need help?
Display
Connectivity
Weight and Dimensions
