Vollmer MAP 200 - SAFETY REGULATIONS

VOLLMER WERKE
Operating instructions
Issue: 01
MAP 200 / 400
Page: 2-1
2 LIST OF CONTENTS
Designation Chapter / page
1 FORWARD......................................................................................................1-1
2 LIST OF CONTENTS ......................................................................................2-1
3 SAFETY REGULATIONS................................................................................3-1
3.1 Explanation of symbols.....................................................................................................3-1
3.2 Transport ..........................................................................................................................3-1
3.3 Machine operation ............................................................................................................3-2
3.3.1 Set-up mode........................................................................................................3-2
3.3.2 Safety devices .....................................................................................................3-2
3.3.3 Staff qualifications ...............................................................................................3-2
3.4 Maintenance, repairs and trouble-shooting......................................................................3-2
3.4.1 Electrical system .................................................................................................3-3
3.4.2 Tools/tool change ................................................................................................3-3
3.4.3 Chemical substances and oils.............................................................................3-3
3.5 Intended purpose..............................................................................................................3-3
3.6 Note on special hazards ...................................................................................................3-3
3.6.1 Hydraulic system, pneumatic system..................................................................3-3
4 TECHNICAL CHARACTERISTICS..................................................................4-1
5 INSTALLATION SITE REQUIREMENTS ........................................................5-1
5.1 Foundation, floor properties..............................................................................................5-1
5.2 Space requirement ...........................................................................................................5-1
6 NOTES ON TRANSPORT AND INSTALLATION............................................6-1
6.1 Slinging points for load-carrying equipment .....................................................................6-1
6.2 Packaging.........................................................................................................................6-2
6.3 Transport ..........................................................................................................................6-2
6.3.1 Transport using fork lift truck or rollers................................................................6-2
6.4 Intermediate storage.........................................................................................................6-2
6.5 Removing the rust protection agent..................................................................................6-2
6.6 Installing the machine.......................................................................................................6-3
6.6.1 Fix the machine to the floor.................................................................................6-3
7 PREPARATIONS FOR START-UP .................................................................7-1
7.1 Connection to the electrical mains....................................................................................7-1
7.1.1 Checking the rotational direction of the motor.....................................................7-1
7.2 Compressed Air Connection.............................................................................................7-1
8 PREPARATION FOR START UP....................................................................8-1
8.1 Elements of the machine ..................................................................................................8-1
8.1.1 Installation of the machine...................................................................................8-1
8.2 Designation of operation elements...................................................................................8-2
8.2.1 Blade driving device ............................................................................................8-3
8.2.2 Auxiliary driving device (Only for MAP400).........................................................8-3
8.2.3 Measuring device ................................................................................................8-3
8.3 Control panel ....................................................................................................................8-4
8.3.1 Key functions of control panel .............................................................................8-4
9 PROGRAM DESCRIPTION.............................................................................9-1
9.1 Operating cycle.................................................................................................................9-1
9.1.1 Starting ................................................................................................................9-1
9.1.2 Parameters..........................................................................................................9-1
9.1.3 Manual operation.................................................................................................9-1