Vollmer MAP 200 - Control Panel Functions

Issue: 01
Page: 8-4
Operating instructions
VOLLMER WERKE
MAP 200 / 400
8.3 Control panel
8.3.1 Key functions of control panel
Indicator lamp "Attention"
When the main switch is turned on, this indicator lamp lights up, signalling that the
machine is ready for operation. During operation, if the indicator lamp is ...
off : the machine is in automatic mode
on : attention is required (after end of automatic sequence, set-up mode)
flashing : a fault has occurred (mechanical faults, insufficient coolant, etc.)
7
8 9
4 5 6
1 2 3
. 0 +/-
Decimal keyboard
For input of the programming datas (numerical
values)
CLR
ENTER
ENTER key
Confirmation of entered program datas
CLR key
Reset of parameters