VOLTCRAFT DL-240K - Initial Operation; Initial Setup Steps; Computer Connectivity and Disconnection; Start;Stop Mode and Time Configuration

38
9. Initial operation
a) Protective cap
 Thedataloggerisonlydusttightandjetwaterprotectedwithattachedprotectivecap(10) and rubber seals
(8). This protection allows permanent logging operation in damp rooms and outdoors.
• Onlyremovetheprotectivecapforreplacingthebatteryorreadingthedataonthecomputer.
• Removetheprotectivecapbypullingitofffromthedatalogger.Theprotectivecaptstightlyduetotherubber
seal (8).
• Placetheprotectivecaptightlybackontothedatalogger.
b) Connect to the computer
• Removetheprotectivecap(10) from the data logger.
• ConnectthedataloggertoanavailableUSBportofyourcomputer.
• Thecomputerrecognizesthenewhardware.Themodeltypeofyourdataloggerappearsasamassstoragedevice
on your computer.
c) Disconnect from the computer
• Ejectthedataloggerfromyourcomputerandremoveit.
• Placetheprotectivecapbackonthedatalogger.
d) Choose start/stop mode
• Choosestartmodefrom“RECORDSTARTCONDITION”duringconguration.
• Choosestopmodefrom“STOPSTYLE”duringconguration.
e) Dene date and time during conguration
• Selectmonth,yearandtimewithdatepickerandtimesliders.Thetimewillbeshownas“TIME”inHH:MM:SS
format.Conrmwith“DONE”.Dateandtimesettingsaredisplayedinthecorrespondingelds.
• Alternatively,click“NOW”,ifyourequireanimmediatestartoflogging.Actualdateandtime-asperlocallyseton
yourcomputer-willbelledautomaticallyintoeld“STARTTIME”/“STOPTIME”.
f) Button ENTER
• Press button ENTER (7) to switch between maximum and minimum reading.
• Press and hold button ENTER (7)forfewsecondstostart/stoploggingoractivate/deactivatepausefunction.