VOLTCRAFT DL-240K - Configure via Software; Create and Load Config File via Software; Configure via Website; Website Configuration File Management

41
c) Create conguration le by software and load the conguration le created
from software onto data logger
• Connect the data logger to your computer.
• Start the Voltsoft software and follow the operating instructions in the software manual (section 6 and choose your
supporteddevice).
• Disconnect the data logger from your computer.
d) Perform conguration setting on the website
Thereare3optionstoopenthecongurationwebsite:
• Open www.conrad.cominabrowserandnavigatetothedataloggerproductpagebyusingtheitemnumber(e.g.
1931526).Clickonthelinkforthecongurationwebsitetoopenthewebsite.
• Open http://datalogger.voltcraft.com/CongBuilder/index.jsp in a browser.
• Connectthedataloggertoyourcomputer.Openthedataloggerdriveonyourcomputer.Clickonthelink“Congu-
rationWebsite.html”toopenthecongurationwebsite.
Main Screen - Overview
General Settings
Choosethedesiredlanguageforthewebsitebyclickingonthecorrespondingag.
Select the model of your data logger. The model name is mentioned on the
packaging and/or product. Chosen model type will be highlighted in red.
MEASUREMENT options
Hereyouselecttheloggingparametersforyourdatalogger.
Forfurtherinstructions,pleasereferto“MEASUREMENT”options-“BASIC
SETTING”onpage42and“MEASUREMENT”options-“ALARMSETTING”on
page 43.
PDF REPORT OPTIONS
HereyoudenethecontentandnameofthePDFreport.
Forfurtherinstructions,pleasereferto“PDFREPORTOPTIONS”onpage44.
Other settings
Hereyoucancreatethecongurationle,loadaprevioussettingorrestoreentries
to default.
Forfurtherinstructions,pleasereferto“Othersettings”onpage44.