VOLTCRAFT DL-240K - Operation Modes and LC Display; Operation Modes Overview; Logging Scenarios (Mode 1-6)

46
12. Overview of operation modes, settings and
LC Display indications
a) Operation modes and settings
Forperformingfollowingcongurationsettings,pleasereferto“MEASUREMENT”options-“BASICSETTING”on
page 41.
Mode 1
Function Logging starts immediately.
Logging stops when memory is full.
Setting Select“IMMEDIATELYUNTILMEMORYFULL”as“RECORDSTARTCONDITION”.
Mode 2
Function Logging starts immediately.
Logging stops when button ENTER (7) is pressed for few seconds.
Setting Select“IMMEDIATELYUNTILMEMORYFULL”as“RECORDSTARTCONDITION”.
Select“STOPBUTTON”as“STOPSTYLE”.
Mode 3
Function Logging starts immediately.
Logging stops after PDF report generation.
Setting Select“IMMEDIATELYUNTILMEMORYFULL”as“RECORDSTARTCONDITION”.
Select“AFTERPDFCREATED”as“STOPSTYLE”.
Mode 4
Function Logging starts when button ENTER (7) is pressed for few seconds.
Logging stops when memory is full.
Setting Select“STARTUPONKEYPRESS”as“RECORDSTARTCONDITION”.
Mode 5
Function Logging starts and stops when button ENTER (7) is pressed for few seconds.
Setting Select“STARTUPONKEYPRESS”as“RECORDSTARTCONDITION”.
Select“STOPBUTTON”as“STOPSTYLE”.
Mode 6
Function Logging starts when button ENTER (7) is pressed for few seconds.
Logging stops after PDF report generation.
Setting Select“STARTUPONKEYPRESS”as“RECORDSTARTCONDITION”.
Select“AFTERPDFCREATED”as“STOPSTYLE”.