VOLTCRAFT DL-240K - Thermocouple Type and Offset Settings

51
e) Setting the thermocouple type
A short press on the DOWN (5) indicates the thermocouple type setting.
To change the sensor type, press the ENTER (7) until MODE appears on the display and then press the DOWN (5)
repeatedly until the desired sensor type is selected. Press ENTER (7)toconrmuntilMODEisnolongerdisplayed.
f) Setting the thermocouple offset
A short press on the DOWN (5) indicates the offset setting.
To change the offset in probe type setting mode, press and hold the ENTER (7) until MODE appears on the display.
Nowthevaluecanbechangedby-0.1bybrieypressingtheDOWN (5) and by -1.0 by pressing and holding it down.
Thevalueisreducedto5.0andthenjumpsto5.0andcanbereducedto0.0.Toconrm,presstheENTER (7) until
MODE is no longer displayed.
long press
ENTER to the
type setting
mode
short press
DOWNchange
type
long press
ENTERtosave
offset.
long press
ENTER to the
type setting
mode
short press
DOWNchange
type
long press
ENTERtosave
offset.