Voltech PM1000+ - Page 40

REMOTE OPERATION
Page 40 © Voltech 2010 PM1000+ Power Analyzer User Manual
“:COM:ETH:MAC?”
Returns Ethernet MAC address to the
user in hex string format.
“:COM:ETH:STAT <value>”
Sets way in which IP address is obtained.
<value> = 0 → DHCP
<value> = 1 → Static IP settings
“:COM:ETH:STAT:GATE xxx.xxx.xxx.xxx”
Sets the static default gateway.
“:COM:ETH:STAT:GATE?”
Returns the stored static Default Gateway.
“:COM:ETH:STAT:IP xxx.xxx.xxx.xxx”
Sets the static IP address.
“:COM:ETH:STAT:IP?”
Returns the stored static IP address.
“:COM:ETH:STAT:SUB xxx.xxx.xxx.xxx”
Sets the static subnet mask.
“:COM:ETH:STAT:SUB?”
Returns the stored static Subnet Mask.
“:COM:ETH:STAT?”
Returns the status of Static IP enabled
flag to the user. 0 -> DHCP, 1 -> Static.
“:DSE <value>”
Sets the Data Status Enable Register
(DSE). The <value> sent is a decimal
value.
“:DSE?”
Returns the Data Status Enable Register
(DSE) as decimal value.
“:DSR?”
Returns the Data Status Register (DSR)
as decimal value.
“:DVC”
Device clear. Sets device to default
settings. This command leaves
communication settings unchanged.
":FRD?”
Returns the selected values
":FRF?”
Returns the current selection list
":FSR:VLT”
Sets the frequency source for voltage
":FSR:AMP”
Sets the frequency source for current
":FSR?”
Returns the freq source 0 = volts 1 =
amps