Volvo D24 - Set Camshaft Position; Tighten Camshaft Front Sprocket; Disconnect Cold Start Device

Group 2l
Engine
Basic
setting
C7
Set camshaft
position
Place
gaLrge
5190 at rear of camshaft.
Insert a 0.2 mm
(0.008
in) ieeler
sause
beneath lefi side of
sause
to
compensate
for timing
gear
clear;nce.
Camshafi;s now set at correct
position.
C8
Make sure cyl. no.
1 is
Check
0 mark
on flywheel
at top dead center
and adiust if necessary.
C9
Tighten
camshaft front
sprocket
Use 5199 to
prevent
sprocket from
turning. Make sure
that
camshaft does not
turn.
Torque
center bolt to 4s Nm
(33
ft lbs).
c10
Remove
gauge
5190 and leeler
gauge
cl1
Disconnect
cold start device
Slacken screw 1. Push lever
forward and rotate sleeve
90". Notel Do not
turn screw 2 otherwise it will be
necessary
to
remove
cold start device and reset it on a
)r