Checking the oil level
Front axle wheel gears
The front axle should be raised.
1 Clean around the level/filler plugs (A) for the
wheel gears
2 Turn the wheel so that the level mark on the
level/filling hole is horizontal
3 Remove the level/filler plug and check that the
oil level reaches up to the edge of the filling hole
4 Top up with oil as necessary
5 Install the level/filler plugs for the wheel gears. If
a seal ring on any of the plugs is damaged, the
seal ring must be changed
J1007657
Front axle differential carrier
1 Clean around the level/filler plug (A).
2 Remove the level/filler plug (A), and check that
the oil level reaches up to the edge of the filler
hole.
3 Top up with oil as necessary.
4 Refit the level/filler plug (A).
If the filler plug has a sealing washer, the sealing
washer must be replaced.
J1007658
568
Maintenance
To Next Page
