Vox Tonelab EX - Cabinet and Pedal Controls; Gain, Tone, and Reverb Controls

3
b. STAND ALONE PEDALS switch and LED
Usethistoturnthestandalonepedalo
n/off.
TheLEDwill
belit‐upifth
estandalonepedalison.
c. CABINET ON/OFF switch and LED
Thisturnsthecabinetmodelon/off.TheLEDwillbelitifthe
cabinetmodelison.
ByenteringtheOPTIONparametersettingmodeyo
ucanset
parametersforthecabinetmodel.
The OPTION parameter setting mode
Toen
tertheOPTIONparametersettingmode,holddownthe
CABINETON/
OFFswitchforaboutonesecond.You’llbein
TheOPTIONparametersettingmode,andthe LE Dwi ll
blink.
TheOPTIONparameter
settingmodeletsyouadjustthefol‐
lowingsettings.
• GAINcontrol:cabinetmodel(CABINETSELECT)
• TREBLEcontrol:presence(PRESENCE)
• MIDDLE
control:noisereduction(NR)
• BASScontrol:TotalEqualizerHigh(E
QHI)
• REVERBcontrol:Tot
alEqualizerLow(EQLO)
• VOLUMEcontrol:Trim(TRIM)
Toreturntothepreviousoperation,presstheCABINETON/
OFFswitchortheEXIT/TUNEswitch.
NOTE: Total Equalizer is enabled only when the AMP/LINE
switchissettoLINE.
NOTE: Presenceis effectiveonlywhentheampmodelorthe
standalonepedalisturnedon.
d. AMPS/STAND ALONE PEDALS selector
Thisselectstheampmodelorthestandal
onepedal.
Thetypeyouselectwillde
terminethe responseofthegain
circuitandtonecontrols,andtheorderinwhichtheyare
locatedinthecircuit.
Iftheampmodelandstandalone pedalsareturnedoff,rotating 
thisselecto rwillturntheampmodelorstandalonepedalon.
e. GAIN control
Thisadjuststhegain oftheselectedampmodelor stand
alonepedal.
IntheOPTIONparametersetting
mode,thiscontrolsel
ects
thecabinetmodel.Ifthecabinetmodelisturnedoff,turning
thiscontrolintheOPTIONparametersettingmodewillturn
thecabinetmodelon.
f. TREBLE, MIDDLE, BASS controls
Theseadjustthetoneofthehigh,mid ,andlowfre
quency
ranges.Thewaythesecontrolsaffectthetonewilldependon
themodelyou’veselected.
NOTE: Depending on the selected amp model, theremay be
almostnosoundifyouturnallthreeofthesecontrols
tothefarleft.
IntheOPTIONparametersettingmode,theTREBLEcontrol
adjuststhepresence,theMIDDLEcontroladj uststhenoise
reduction,andtheBASScontrolenab lesyou toadjustthe
TotalEqualizerHigh.
g. REVERB knob
Dependingonthepositionoftheknob,thisselec
tsthereverb
type(SPRING,ROOM,orHALL),andadjuststheamountof