Vox Tonelab EX - Bank Select Section; Program Select and Tuning Indicators

4
reverbinthemix.Ifyouturntheknoballthewayto
theleft,
thereverbeffectwillbeturnedoff.
IntheOPTIONparametersettingmod e,this controlknob
enablesyo
utoadjusttheTotalEqualizerLow.
Fordetailsoneacheffect,referto“Reverbtypes”(p.29)
h.
VOLUME control
Thisadjuststhevolumeoftheprogram.
IntheOPTIONparametersettingmode,itenablesyou to
selectTrim.
HINT: You can adjust the volume of theprogram even when
theampmodelisturnedoff.
2.Bank select section
a. BANK UP/DOWN pedals
a
a
Inprogramselectmode,thesepedalsenable
youtoselectaprogrambank(p.10,“Trying
outtheTone
LabEX”).
PressingtheBANKUPpedalwillincrement
thebank byone,andpressingtheDOWN
pedalwilldecreasethebankbyone.
Thebanknumberwillbedisplaye
dinthe
Bank/Valuedisplay.
If yo u presstheUP and DOWN pedal s
si
multaneouslyforaboutone second ,the 
“
”indicatorwillappearontheBank/Valuedisplay,and
theunitwillenterStompBoxMode.InStompBoxMode,
thesepedalsturnonorofftheamp/standalonepedalandthe
effectassignedtopedal1individually(p.11,“StompBox
Mode”).
3. Program Select/Tuner/Stereo Speakers section
cc
a
b
a. Program 1–4 pedals and LED
Inprogramselectmode
,thesepedalsenableyoutoselectapro‐
gramfromabank(p.10,“TryingouttheToneLabEX”).Ifyou
selectaprogram,aprogramLEDthatcorrespondstotheselected
programwillbelit‐upred.(Program1–4LEDsarelocatedabove
theprogram1–4pedalsandindicatethetuningstatus.)
HINT: Youcansetthedelaytimeusingtheprogram1–4ped‐
als.Inthiscase,theintervalatwhichyoutaptwiceona
programpedal(thatcorrespo ndstotheselectedpro‐
gram)willbeassignedasthedelaytime.
HINT: Ifyoupressandholddowntheprogrampedalthatcorre‐
spondstothecurrentprogramforaboutonesecond,allef‐
fectswillbebypassedandyo
uʹllbeabletousethetuner.If
youholddowntheprogrampedalforabouttwoseconds,
youʹllbeabletousethetunerwiththesoundmuted.
InStompBoxMode ,thesepedalsturnonor offthepedal 2
effect,modulationeffect,delayeffect,andreverbeffectindivid‐
ually.Whenaneffectisturnedon, thecorrespondingprogram
1–4pedalLEDwillbelit‐upred(p.11
,“StompBoxMode”) .