Vox Tonelab EX - Pedal 1 Controls; Pedal 2 and Modulation Controls

5
b. TUNER LED
Theseli
ghtsareusedfortuning(p.29,“Tuner
”).
Whenyou’reusingthetuner,theLEDswillindicate thetun‐
ingstatus.
c. S
tereo speakers
Youcanlistentothesoundoutputfromthebuilt‐instereo
speakers.Toadjustthevol u me level,usetheSPEAKER
LEVELcontrolontherearpanel(p.8).
NOTE: Thespeakerswillbemutedwhenacableisconnected
totheOUTPUT/PHONESjack.
NOTE: Someprograms(especiallythosewithanemphasized
lowrange)maycausethesoundfromthespeakersto
bedistortedornoisy.Insuchacase,adjustthevolume
levelusingtheSPEAKERLEVELcontrol.
4.Pedal 1 section
b
a
Hereyoucanadjustthesettingsforthe
pedal1effects.
Fordetailson eacheffect,referto
“Pedal
1”(p.23)
a. PEDAL 1 ON/OFF switch and LED
Thisturnsthepedal1effecton/off.
TheLED willbelitifthepedal1effectison.
b. PEDAL 1 knob
Rotatingthis knobenablesyou toselec
tthepedal1effect
typeandadjuststheeffectparametersassignedtoeacheffect.
Ifthepedal1effectisturnedoff,rotatingthisselectorwill
turnthepedal1effecton.
5.Pedal 2 section
Hereyoucanadjustthesettingsforthepedal2effects.
Fordetailsoneacheffect,referto“Pe
dal2”(p.24).
a. PEDAL 2 ON/OFF switch
and LED
b
ac
Thisturnsthepedal2effect
on/off.TheLEDwillbelitif
thepedal2effectison.
b. PEDAL 2 selector
Thisselectsthepedal2type.
Ifthepedal2effectisturned
off,turning thissele
ctorwill
turnthepedal2effecton.
c. EDIT knob
Thisadjuststheparametersofeacheffect.
6.Modulation section
b
a cd
Hereyou can adjust the set‐
tingsforthemodulationeffect.
Fordetailsoneacheffect,refe
r
to“Modulation”(p.25).
a. MODULATION ON/OFF switch
and LED
Thisswitchturnsthemodula‐
tioneffecton/off.
TheLEDwillbelitiftheeffectison.