The power plug of the touch screen, which is connected to the simulator PC, has a
locking mechanism that prevents the plug from being unplugged accidentally. With-
out unlocking the plug, you may cause damage to the plug or the connector of the
simulator PC. When unplugging the power plug, hold the power plug on the rippled
part of the plug housing.
If the bayonet lock of the microscope is opened, the eyepieces can fall off and
cause injury or get damaged. When opening the bayonet lock make sure to hold
the eyepieces firmly so they cannot fall down.
Transport
Transport the simulator in the original transport boxes in which it was delivered.
The packaged simulator is heavy. Trying to move or to lift the simulator on your own
could cause injury or damage to the simulator. The shipping boxes should be trans-
ported with a pallet truck only. Always place the transport boxes on a level, stable
surface that can securely bear the total weight. Make sure that the transport boxes
cannot fall.
Storage
Observe the storage conditions for the simulator (Â section 9 on page 66). We
recommend storing the simulator in its original transport boxes.
Make sure that the storage location is dust-protected and dry. If the simulator is not
in use for a longer time, we recommend covering the simulator hardware to protect
it from dust. Do not store other objects on top of the simulator and ensure that no
other objects can fall onto the simulator.
2.11 Care, Maintenance, and Disposal
Care
If water enters any of the simulator components, there is the risk of death or serious
injury through electrical shock. Further, the simulator might get damaged through
short circuits and resulting heat. Make sure that water does not enter any of the
simulator components. Disconnect all simulator components from power before
attempting to clean them with a damp cloth. Make sure that the simulator does not
get wet while cleaning surrounding areas (e.g. while wet mopping the floor).
Maintenance
Never attempt to make any repairs, manipulations or alterations of any nature to the
simulator. Never open the housings of the simulator components. Doing otherwise
may lead to personal injury and voids the warranty.
If you attempt to change the fuses while the simulator is connected to power, there
is the risk of death or serious injury through electrical shock. Always disconnect the
simulator from power before changing the fuses.
13
Safety
Eyesi Surgical Simulator – Installation and Operating Guide
To Next Page
Loading...