VTech IS7121A - Install and Charge Handset Batteries

6
SET UP THE TELEPHONE
2.5 Install and Charge the Handset Batteries
Slide open the battery compartment cover.
Place the supplied rechargeable battery in the battery compartment, with the battery connector
plugged in, as shown.
Slide the battery compartment cover back on until it clicks into place.
Place the handset on the base to charge for at least 16 hours. The Charging LED lighting up
indicates that the handset is properly placed on the base.
noteS
Use only the supplied NiMH rechargeable batteries.
If you do not use the handset for a long time, disconnect and remove the batteries to prevent
possible leakage.
1.
2.
3.
4.
•
•
Battery Pack BT164392/BT264392 2.4V 550mAh Ni-MH WARNING : DO NOT BURN OR PUNCTURE BATTERIES Made in China CR1222
Battery Pack / Bloc-piles : (2.4V Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
CR1232
Battery Pack / Bloc-piles : (2.4V Ni-MH) WARNING / AVERTISSEMENT : DO NOT BURN OR PUNCTURE BATTERIES. NE PAS INCINÉRER OU PERCER LES PILES. Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
CR1232
CHARGE light
remains on
when charging.