16
SET UP THE TELEPHONE
2.9 Install the Doorbell Wall Mount Cover
Make sure to test the reception and the doorbell position before you mount the doorbell on the wall.
See Locating the doorbell on pages 11-15 to choose a desirable position for the doorbell.
Use a pencil to mark two holes on the desired location. Then remove the wall mount and drill two
holes in the wall. Check for reception strength and camera angle before drilling the holes.
1.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall anchors into the holes and tap
gently on the ends with a hammer until the wall anchors are ush with the wall.
To Next Page
Loading...
