SET UP THE TELEPHONE
11
2.8 Locating the Doorbell
Before mounting the doorbell on a wall, make sure you test if the location you install the doorbell is in
range, and adjust the camera angle to best suit your needs.
To test the location for installation:
Hold the doorbell in the location where you want to install the doorbell, then follow the steps below to
test the reception range and video capture angle.
Press MENU >> Press
p
q
to Settings >> Press SELECT.
Press
p
q
to Doorbell setup >> Press SELECT.
Press /DOORBELL to check the video streaming quality.
The handset displays The handset is muted during the setup mode, then press OK.
Press ISO, then press + or - to adjust the video streaming brightness.
If audio feedback occurs, press on the handset to turn off the speakerphone.
If the desired location is in good range, the handset displays .
If the desired location is not in good range, the handset ashes in red. Press INFO for
instructions to relocate your handset and/or telephone base. When the reception is in good
range, the handset displays . Press OK to return to the video streaming.
1.
2.
3.
4.
5.
•
•
•
To Next Page
Loading...
