SET UP THE TELEPHONE
13
The diagrams below demonstrate an example of doorbell camera position to view a visitor about
20 inches from the camera. The camera in this example is set in default angle (0 degree).
You may move the lever at the back of the doorbell to adjust the shooting area (the camera lens).
Test at the front door to determine when the infrared LEDs turn on. When they are in operation, they
turn red.
To adjust the shooting area, you may either relocate the doorbell in different height level, or adjust
the camera angle (see below).
To adjust the camera angle:
Tilt the lever to adjust the angle of the camera lens. The camera lens can be adjusted to left, right
or down, up to 10 degrees.
•
To Next Page
Loading...
