VWR CO2 Incubator Basic - Page 56

| Cleaning and disinfection
54 | CO2 Incubator Basic VWR
Chapter 9
Alcoholic disinfectants:
Disinfectants with an alcohol content of more than 10% may form, in combination with air, easily
combustible and explosive gas mixtures.
When using such disinfectants, avoid open flames or exposure to excessive heat during the entire
disinfection process!
 Use such disinfectants only in adequately ventilated rooms.
 After the disinfectant has been allowed to react, wipe the cleaned device components
thoroughly dry!
 Observe safety regulations to avoid fire and/or explosion hazard caused by alcohol-containing
disinfectants!
Recommended disinfectant:
A surface disinfectant recommended by VWR can be ordered under following part numbers:
 Spray bottle, 250 ml: Part No.: 50052425
 Refill bottle, 500 ml: Part No.: 50051939
NOTE!
Description disinfectant:
Details for efficiency and approvals are available on request!
Preparing the manual wipe/spray disinfection:
WARNING!
Electric shock:
Contact with current-carrying components may cause a lethal electric shock.
Prior to cleaning and disinfection work, disconnect the device from the power supply!
 Turn the device off using the power switch.
 Unplug power connector and protect it against accidental reconnection.
 Check to see if the device is de-energized!
CAUTION!
Health hazard:
The surfaces of the work space may be contaminated. Contact with contaminated cleaning liquids
may cause infections. Disinfectants may contain harmful substances.
When cleaning and disinfecting, always observe the safety instructions and hygiene regulations!
 Wear safety gloves.
 Wear safety glasses.
 Wear mouth and respiratory system protection gear to protect the mucous membranes.
 Observe the safety instructions of the manufacturer of the disinfectant and of the hygiene
experts!