2-8 BA DT08 SL EN – Edition 1.0 * * dt08b210.fm
Safety instructions
• Have loads fastened and crane operators guided by experienced persons only!
The person guiding the operator must be within sight or sound of him
• Always use specially designed or otherwise safety-oriented ladders and working
platforms to carry out overhead assembly work.
Never use machine parts or attachments/superstructures as a climbing aid!
Wear a safety harness when carrying out maintenance work at greater heights!
Keep all handles, steps, handrails, platforms, landings and ladders free from dirt, snow
and ice!
• Clean the machine, especially connections and threaded unions, of any traces of oil,
fuel or preservatives before carrying out maintenance/repair work!
Do not use aggressive detergents!
Use lint-free cleaning rags!
• Before cleaning the machine with water, steam jet (high-pressure cleaner) or deter-
gents, cover or tape up all openings which – for safety and functional reasons – must
be protected against water, steam or detergent penetration. Special care must be taken
with the electrical system.
• After cleaning, remove all covers and tapes applied for that purpose!
• After cleaning, examine all fuel, lubricant and hydraulic oil lines for leaks, chafe marks
and damage!
Rectify all defects without delay!
• Always tighten any screw connections that have been loosened during maintenance
and repair!
• Any safety devices removed for set-up, maintenance or repair purposes must be
refitted and checked immediately upon completion of the maintenance and repair work.
• Ensure that all consumables and replaced parts are disposed of safely and with
minimum environmental impact!
• Do not use the work equipment as lifting platforms for persons!
• Before taking up work on machine parts dangerous for life and limb (bruising, cutting),
always ensure safe blocking/support of these areas
• Carry out maintenance and repair work beneath a raised machine, attachments or
additional equipment only if a safe and secure support has been provided for (the sole
use of hydraulic rams, jacks etc. does not sufficiently secure raised machines or
equipment/attachments)
• Avoid contact with hot parts, such as the engine block or the exhaust system during the
operation of the machine and for some time afterwards – danger of burns!
• Retainer pins can fly out or splinter when struck with force – danger of personal injury!
• Do not use starting fuel! This especially applies to those cases in which a heater plug
(intake-air preheating) is used at the same time – danger of explosions!
• Apply special care when working on the fuel system – increased danger of fire!
To Next Page
Loading...
Need help?
General
