EasyManuals Logo

Wacker Neuson DT08-D User Manual

Wacker Neuson DT08-D
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
BA DT08 SL EN – Edition 1.0 * dt08b340.fm 3-23
Operation
1.01.03
3.4 Working with the machine
General safety instructions
Never drive up to the edge of a pit from outside – danger of cave-in!
Do not drive under projecting earth. Stones or earth can fall onto the machine.
When working on roofs or similar structures, check the resistance and the structure
itself before starting work. The building can collapse, causing severe injury and
damage to property.
Do not place the machine directly under the workplace during demolition, otherwise
demolished parts can fall onto the machine or the building can collapse, causing severe
injury or damage.
Operation of the machine by unauthorised staff is prohibited!
The hydraulic system of the machine is still pressurised even when the engine is not
running! Release the pressure in the sections of the system and hydraulic lines which
are to be opened before starting setup or repair work, e.g. fitting/removing an
attachment with hydraulic functions.
Before dumping out the skip next to an excavation, secure the machine with suitable
wheel chocks or other auxiliary means.
Always watch the material as you dump out the skip: ensure that the material is
dumped out evenly and does not remain stuck in the skip, otherwise the machine could
tip over.
Do not dump the load when working on sloping ground.
No transporting of persons, animals etc. in the skip.
When transporting material, actuating the skip and/or the loader unit (option) is not
allowed!
Always carry out precise and smooth control movements, do not carry out abrupt
movements.
Do not get off the machine when it is moving.
Avoid dangerous work conditions on the work site, do not work in severe weather and
ensure that no-one is at risk.
Transporting persons is prohibited.
Working with the loader unit
The following section describes work operations with the machine equipped with the
loader unit. The loader unit is mainly used for earth-moving applications, and for loosening,
picking up and loading loose material.
Transporting with a full bucket
Caution!
No transport of material: the loader unit is designed for loading loose material
only.
Loading loose material is described below
Only load material with the skip dumped in
Operation

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson DT08-D and is the answer not in the manual?

Wacker Neuson DT08-D Specifications

General IconGeneral
BrandWacker Neuson
ModelDT08-D
CategoryConstruction Equipment
LanguageEnglish

Related product manuals