Wacker Neuson DT08-D - Engine Oil Level and Filling Procedures

5-8 BA DT08 SL EN – Edition 1.0 * * dt08b510.fm
Maintenance
5.3 Engine lubrication system
Caution!
If the engine oil level is too low or if an oil change is overdue, this can cause
Loss of output and engine damage!
☞ Have the oil changed by an authorised workshop
– see chapter 5.11 Maintenance plan DT08-D (diesel engine) on
page 5-27
– see chapter 5.10 Maintenance plan DT08-P (petrol engine) on
page 5-25
Checking the oil level
The oil level can be checked from either side.
Notice!
Check the oil level once a day.
We recommend checking it before starting the engine. After stopping a warm
engine, wait at least 5 minutes before checking.
Checking the oil level
☞ Proceed as follows:
• Park the machine on level ground
➥ Max. inclination about 5°
• Stop the engine!
• Oil dipstick A:
☞ Pull it out
☞ Wipe it with a lint-free cloth
☞ Push it back in as far as possible
☞ Withdraw it and read off the oil level
☞ However if necessary, fill up oil at the latest when the oil reaches the MIN mark on the
oil dipstick A
Fig. 75: Oil level check (petrol engine)
max
min
A
Fig. 75: Oil level check (diesel engine)
max
min
A