Wacker Neuson EZ26 - Page 126

5-16 BA EZ26 en/us* 1.0 * EZ26_01_510.fm
5 Operation
ISO/SAE controls (option)
The standard equipment of the vehicle includes ISO controls. SAE
controls are available as an option. This results in a different control lever
operation.
WARNING
Accident hazard due to modified control mode!
Modified controls can cause incorrect operation, and serious injury or
death.
► Before starting work, check the selected control type.
► Secure the wing nut on the changeover lever of the directional valve.
► Do not operate the machine with a defective wing nut. Contact a
Wacker Neuson service center.
The changeover valve is located under a cover on the left behind the seat.
Fig. 134
Wiring diagram Controls
A ISO controls
B SAE controls
Fig. 135
A
B