Auxiliary equipment
Padfoot shells
202
BA RC50_RC70 en 00
6.06 Padfoot shells
DANGER
Risk of being run over by the roller!
Risk of extremely serious injuries or death as a result of being run over
by the roller during installation work.
■
Ensure that no persons are within the danger zone while the
machine is moving.
■
Affix warning signs to secure the danger zone.
■
Be sure to pull out the ignition key even if you only leave the
driver's platform for a short time.
■
To prevent third parties from accidentally switching the machine on:
Affix a warning sign to the driver's platform indicating that work is in
progress on the machine.
WARNING
Heavy weight!
Serious injuries or death caused by crushing or getting caught during
assembly.
■
Perform installation work on firm ground (flat, stable, horizontal).
■
Carry out fitting work only when the engine is stopped.
■
Use suitable load suspension and hitching gear with an adequate
loading capacity.
■
Do not step underneath suspended loads.
NOTICE
Heavy padfoot shell!
Material damage to the machine when fitting/removing the padfoot
shells.
■
Use suitable hoisting gear and lifting tackle with a sufficient load-
bearing capacity.
■
All work must be carried out by two persons.
■
Use safety ropes.
■
Remove components that could be damaged in advance
NOTE
The machine needs to be moved during assembly and
disassembly. To allow for the machine's forward and backward
movement, make certain that there is sufficient space both in
front and behind the machine.
6.06.01 Overview
View without front crossbeam
To Next Page
Loading...
Need help?
General
