Operation
Switching on/off electrical system/on-board power supply
80
BA RC50_RC70 en 00
a
After-running time starts, LED flashes red.
a
The battery is disconnected after approx. 2 minutes.
a
Control unit switches to standby mode.
a
All LEDs off.
Switch off without preselection
Prerequisites:
■
electrical system OFF (ignition key [3] in position 0)
■
Control unit of battery switch-off is activated
Press switch [2].
a
After-running time starts, LED flashes red.
a
The battery is disconnected after approx. 2 minutes.
a
Control unit switches to standby mode.
a
All LEDs off.
Standby mode
Requirement:
Control unit of battery switch-off is activated
Switching off electrical system: ignition key [3] in position 0.
a
Control unit in standby mode, LED flashes green.
a
Battery is disconnected after approx. 24 hours.
Circuit breaker [2] is pressed in stand-by mode.
a
After-running time of approx. 2 minutes starts, LED flashes red.
a
Battery is disconnected after expiry of the after-running time.
Electrical system switched on in standby mode (ignition key [3] in
position I).
a
Machine can be operated normally, the control LED of the control unit
is off.
a
The control unit remains in stand-by mode.
Switch on battery power, start diesel engine
NOTE
After the battery has been disconnected, the control unit has
to be activated in order to switch on the battery voltage. The
battery voltage is switched on without delay.
Press switch [1].
a
LED flashes green.
Switch on electrical system: ignition key [3] in position I.
a
LED lights up green.
a
Brief functional check of all pilot lights
a
The diesel engine can be started.