Maintenance
Control stand
128
BA RD18 en 01
4.02 Control stand
4.02.01 Checking that the drive lever is working properly
Before making the functional check, set the controls to their home
positions:
■
Engage drive lever [1] in the 0-position.
■
Set the motor speed [2] to MIN.
■
Unlock the emergency stop [3].
Functional test
Switch off diesel engine and remove ignition key.
Move the drive lever [1] fully forward and fully backward.
a
The drive lever must allow even movement in both directions without
using excessive force.
Lock the drive lever [1] in its 0 position after the functional check.
NOTE
No machine operation is permitted if the drive lever binds or is
sluggish.
Request assistance from customer services!
To Next Page
Loading...
