Operation
Stopping the machine because of a fault
88
BA RD18 en 01
3.16 Stopping the machine because of a fault
NOTICE
Severe malfunctions!
Damage or destruction of machine components caused by continuing
operation despite serious faults.
■
When a serious fault is indicated, immediately stop the machine at
a safe position outside the danger zone.
■
Determine and remove the cause of the alfuction.
■
Do not use the machine again until the fault has been rectified.
Serious fault
In the event of a serious fault:
a
A permanent acoustic signals sounds.
a
At least one warning light lights up.
a
The system info [1] displays an error code.
a
The STOP warning light [2] flashes.
Stop using the machine.
Park the machine out of the danger zone.
Switch off the diesel engine immediately.
Rectify the cause immediately.
NOTE
Write down the error code indicated. If you cannot correct the
error yourself, please contact the customer service.
The STOP symbol appears when:
■
Hydraulic oil temperature is too high
■
Engine temperature is too high
■
Water in diesel (water sump fuel prefilter)
■
Diesel particle filter (DPF) is too heavily loaded
■
No charge current with diesel engine running.
Note on a fault
If there is a deviation from the normal operating status:
To Next Page
Loading...
Need help?
General
